A good manual handwash is effective at reducing hand bacteria counts, no doubt. However, the manual handwash method cannot be guaranteed to be consistent from person to person and day-to-day, otherwise this would be a good alternative. Manual handwashing is inherently variable. Important aspects of the handwash, such as amount of soap, amount of water, coverage of the hand (fingernails, fingertips, between the fingers, wrist, etc.), and duration of the wash vary from wash to wash. By automating the process, these aspects are closely controlled and each person gets a high-quality handwash independent of the human variability factor. If you have had no problems in the past, then statistically you are overdue for a problem. CleanTech® will standardize each hand wash and guarantee clean hands. Meritech has performed an independent study which demonstrates that our technology-based approach to hand hygiene, with a 12-second cycle, is equivalent to a full 1-minute wash (30 seconds of lathering, 30 seconds of rinsing). 

Because of the high risk of cross contamination! In a study by BioScience Laboratories that tested randomly selected vinyl food grade gloves, 80 percent were found to have pre-existing punctures or tears. In addition, the use of gloves creates the perfect environment for the breeding colonies of pathogens on the hands. When handwashing was performed prior to gloving, no significant microbial growth was observed. In another study, hands that were initially inoculated with E. coli before donning gloves were determined to have significant counts on the outside surface of the gloves after use – this is known as cross contamination and it is why there are many industries that actually discourage glove use. For those companies that do use gloves, the CDC recommends washing before gloving due to the rapid growth of bacteria on gloved hands, and due to the risk of punctures and tears during use. When hands are washed effectively prior to wearing gloves, the risk of cross contamination is reduced but the key is that the manual wash needs to be effective. Only a Meritech CleanTech system can guarantee an effective wash prior to gloving 

Please refer to each model’s spec sheet for details. All systems require the same plumbing as a standard sink; hot & cold water supply and a drain, and 110V power outlet. Note that our systems do not heat the water. The hot water is supplied by the facility and then the system will automatically blend the hot and cold to about 105ºF. If there is a hot water supply problem, a booster heater is recommended and Meritech engineers can help you with specifications for a booster heater. 

CleanTech shines in three areas:

• Standardization: The consistent wash technique, and accurate solutions delivery of the CleanTech system has been clinically proved to be more effective than a manual hand wash.
• Efficacy: The CleanTech system removes transient microorganisms on the hands by 99.98%.
• Compliance: Employees are encouraged to wash hands by the sheer nature of the CleanTech system, including the ease of operation and comfort and the skin friendly conditioning that is included in the wash. In addition, CleanTech monitors compliance by counting washes.